DARTBOARDS / 【TARGET】CORONA VISION REPLACEMENT LED STRIP
SPEC
| Category | Board Related Item |
|---|
TARGET
CORONA VISION REPLACEMENT LED STRIP
PRICE： JPY4,250
Expected：USD 27.50
Expected at JPY 154.56 for 1 USD.
This exchange rate is the closing price of yesterday ( 4/19 ).
The actual exchange rate will be determined when the order is paid.
taa0604
Product information
TARGET CORONA VISION REPLACEMENT LED STRIP
Replacement LED tape that corresponds to the failure of the light lighting part of CORONA VISION
Please use it by recombining the existing parts.
Cannot be used by itself.
Replacement method :
1. Peel off the broken LED tape from the ring.
2. Remove as much of the old adhesive as possible from the ring.
(Please keep the black tape covering the inside of the ring and the joint part)
Align the cable of the new LED tape with the notch in the ring and fix it in place.
3. Peel off the protective film about 10cm from the end of the LED tape cable to expose the adhesive part a little.
4. Insert the LED tape into the inside of the ring from the end of the cable side.
While peeling off the protective film, stick the peeled off part to the inside while applying pressure.
5. The end of the LED tape (not the cable side) and the end of the cable side should be almost aligned when laying.
Lift the starting point of the cable side of the LED tape from the notch, place the end of the LED tape (not the cable side) on the ring, lay the end of the cable side on top of it, and put the cable back on the plug.
Replacement LED tape that corresponds to the failure of the light lighting part of CORONA VISION
Please use it by recombining the existing parts.
Cannot be used by itself.
Replacement method :
1. Peel off the broken LED tape from the ring.
2. Remove as much of the old adhesive as possible from the ring.
(Please keep the black tape covering the inside of the ring and the joint part)
Align the cable of the new LED tape with the notch in the ring and fix it in place.
3. Peel off the protective film about 10cm from the end of the LED tape cable to expose the adhesive part a little.
4. Insert the LED tape into the inside of the ring from the end of the cable side.
While peeling off the protective film, stick the peeled off part to the inside while applying pressure.
5. The end of the LED tape (not the cable side) and the end of the cable side should be almost aligned when laying.
Lift the starting point of the cable side of the LED tape from the notch, place the end of the LED tape (not the cable side) on the ring, lay the end of the cable side on top of it, and put the cable back on the plug.
