Darts Other Item / 【CONDOR】BEAK WITHOUT CUT 38mm
SPEC
| Category | Settings Parts |
|---|---|
| Maker | CONDOR , OTHERS |
| Color | Silver |
| For Setting | Hard Point |
CONDOR
BEAK WITHOUT CUT 38mm
PRICE： JPY1,680
Expected：USD 11.20
Expected at JPY 149.85 for 1 USD.
This exchange rate is the closing price of yesterday ( 3/31 ).
The actual exchange rate will be determined when the order is paid.
tda1012
Product information
CONDOR BEAK
Exclusive points for STEEL DARTS
Jointly developed with a Japanese needle manufacturer, one of the world's three largest manufacturers of needles
The shape of the needle is designed to be easy to puncture and hard to fall off.
Special alloy with high durability and rust resistance is used. Ring cut with a firm edge.
The new DRA rule, which will be enforced from the 2024 season, requires that the surface roughness of the point within 15mm from the tip be within the specified value. Darts boards are less likely to be damaged.
Designed with a wire diameter of φ2.34mm, which has been tested in 0.01mm increments to find the best fit for a variety of barrels. Tolerance of ±0.01mm is achieved by Japanese technology.
1mm pitch guide line is provided for easy length alignment during barrel press fitting.
There is a possibility that some barrels cannot be installed due to the blurring of the diameter setting or tolerance of the hole on the barrel side, regardless of the barrel manufacturer or barrel type.
Please note that this is not a defect of the point or barrel.
WITH CUT / WITHOUT CUT
32? / 38? / 42?
2.34mm diameter ±0.01mm
Material: Special Alloys
Exclusive points for STEEL DARTS
Jointly developed with a Japanese needle manufacturer, one of the world's three largest manufacturers of needles
The shape of the needle is designed to be easy to puncture and hard to fall off.
Special alloy with high durability and rust resistance is used. Ring cut with a firm edge.
The new DRA rule, which will be enforced from the 2024 season, requires that the surface roughness of the point within 15mm from the tip be within the specified value. Darts boards are less likely to be damaged.
Designed with a wire diameter of φ2.34mm, which has been tested in 0.01mm increments to find the best fit for a variety of barrels. Tolerance of ±0.01mm is achieved by Japanese technology.
1mm pitch guide line is provided for easy length alignment during barrel press fitting.
There is a possibility that some barrels cannot be installed due to the blurring of the diameter setting or tolerance of the hole on the barrel side, regardless of the barrel manufacturer or barrel type.
Please note that this is not a defect of the point or barrel.
WITH CUT / WITHOUT CUT
32? / 38? / 42?
2.34mm diameter ±0.01mm
Material: Special Alloys
