Darts Other Item / 【JOKERDRIVER】MAGIC WEIGHT 1.8g
( 2 )

SPEC

Category Settings Parts
Maker JOKER DRIVER , OTHERS
For Setting Weight ball
JOKERDRIVER
MAGIC WEIGHT 1.8g
PRICE: JPY748
Expected:USD 4.77

Expected at JPY 156.51 for 1 USD.

This exchange rate is the closing price of yesterday ( 12/22 ).

The actual exchange rate will be determined when the order is paid.

joa0112

Product information

MAGIC WEIGHT

MADE IN JAPAN weight & balance adjustment weight.
Use nippers to cut the length of the weight to fit your barrel.
If you can't cut it cleanly, please use a file to adjust the length.

You can customize your barrel by combining with JOKER Adjustment Weight and JOKER SPRING.
The spring prevents the WEIGHT from moving inside the barrel during take back and release.

[Contents].
MAGIC WEIGHT / 3pcs, SPRING S-size / 3pcs

[Size]
1.3g=length19mm/max dia3.5mm/TUNGSTEN95%.
1.8g=length21mm/max dia3.6mm/TUNGSTEN95%.
All figures are hand-measured and average values. Please consider it as a guide.

2BA barrels need to be cut about half (or more depending on the barrel).
4BA (reverse thread) and NO.5 type can only be used at the back of the barrel.
It is possible to use only the bar part by cutting off the pointed part of the tip.
If it gets stuck in the barrel. Repair, replacement and warranty are not available. Please use at your own risk.
If you push it too hard, it may get stuck in the spring.
If the spring is weakened by normal use, it may get stuck.

【KTM.が選ぶ!】DARTS OF THE YEAR【珠玉の逸品!】

7

ミニ四駆とか好きな人とかの、カスタム心をくすぐるものじゃないかな。今使ってるバレルで重量調整が出来るっていう点と、手を出しやすい値段っていう点が評価できる。

その他の受賞作品はこちらKTM.

Japan Review

3.50

2 Reviews

0
1
1
0
0
Sort By :

2016-07-01

I purchased this because of the light weight of Tradience 1.
It can be used after cutting, but the cut surface is not flat, so I flattened it with a file.
After installing it, it still rattles inside, so if you are concerned about this, you should use a spring in combination with it.
However, after installation, the flight is more stable and I am personally satisfied!

3 people found this helpful

2017-07-07

When put in the shaft side of the Target Pyro2 (16g).
The following values are approximate.
If you use it from the tip, you can use 0.48g.
If you cut off the tip and make it into a stick shape, you can use 0.68g.
The conclusion is that it does not fit in more than expected.

As a recommendation, purchase an additional spring S (10mm).
Use the tip on the shaft side and put the remaining bar on the tip side.
This will increase the weight by at least 1g.

It is difficult to adjust because it is cut with nippers.
I would like to know how other people use it.

Also, it would be good to see the depth with a splitter or something before cutting.

3 people found this helpful