【JOKERDRIVER】MAGIC WEIGHT 1.8g 's Japan Review

I purchased this because of the light weight of Tradience 1.
It can be used after cutting, but the cut surface is not flat, so I flattened it with a file.
After installing it, it still rattles inside, so if you are concerned about this, you should use a spring in combination with it.
However, after installation, the flight is more stable and I am personally satisfied!

When put in the shaft side of the Target Pyro2 (16g).
The following values are approximate.
If you use it from the tip, you can use 0.48g.
If you cut off the tip and make it into a stick shape, you can use 0.68g.
The conclusion is that it does not fit in more than expected.

As a recommendation, purchase an additional spring S (10mm).
Use the tip on the shaft side and put the remaining bar on the tip side.
This will increase the weight by at least 1g.

It is difficult to adjust because it is cut with nippers.
I would like to know how other people use it.

Also, it would be good to see the depth with a splitter or something before cutting.