【DMC】dmt0005 's Japan Review

A little easy to break? But I am satisfied with it.

The tip tip tip is thicker than the other tips, so it sticks shallowly in darts live segments, and often does not stick (it is not "bounced" but does not stick in the first place). It depends on how you fly, but I think it is a tip for different people.

Also, when attaching the tip to the barrel, the screw is too tight and does not turn all the way in.

These are not all the tips in a bag, some stick in properly and some are not hard.
The precision of the finish is uneven, so if they could unify that and make them stick properly and not too hard and tight, that would be the tip for 4BA! It would be a waste.

As for the sticking, it may stick in the segment of old machines, but I think it is too hard in today's machines (not sure about Phoenix).

I am writing again because a concern has come up.
I purchased this for a lighter stainless steel Accuto-type and used it in conjunction with a lip.
At this stage, I wrote last time that there was not much difference between the two....
I think it may be due to the weight and the trajectory of the darts, but when I observed the tip, it seemed to have a shallower and stiffer sting than the lip.
If you want your tip to always be straight and stiff, this is the way to go.
For those who prefer to stick into the board even if it bends a little, I would use the lip point, and I would use different points depending on the weight of the barrel.
I hope the "4BA" will come close to the quality of the 2BA.