【L-Style】GOMU 's Japan Review

I used it with my darts friends for fun, but honestly speaking, sticker tape is sufficient.
One set of sticker tape costs 300 yen, which is too expensive.
You can use more than 50 sets of sticker tape for 100 yen.

As others have said, it is very tight when tightening.
I think you can feel the difference if the shaft is made of carbon, but if it is made of plastic, it is hard to tell the difference, and considering the cost, it doesn't make much sense.

I would recommend this product to those who are stressed by looseness.

It doesn't loosen up. That part is good. But disposable is a little bit... Also, when I remove it, the tip of the GOMU? I pointed it with a hard conversion and turned it in the opposite direction while pushing it on the threading. I used a hard conversion tool to take it off by turning it in the opposite direction while pushing it onto the threading.
If you want, I think it would be better to make a shaft with a slightly rubbery texture like Condor Flight's.

With ordinary O-rings, the protrusion of the rubber is a concern, and if you try to prevent it from protruding, you may end up with a gap between the shaft and the barrel part.

I used to use O-rings, but I think I will use this from now on.

This is my impression after buying it at a certain place on the day of release, putting it on immediately and throwing it for 4 hours.

It doesn't loose ！！！！！！！！

I have always been stressed by the loosening of the screw when using carbon shafts, but after wearing the GOMU, I can say that it does not loosen at all, and I have no more stress caused by loosening.

I know they are disposable, but I don't mind that much because they come in packs of 6, and they are inexpensive, so I think they are very cost-effective.

I really recommend it to L-style users!

However, please note that they cannot be used for some manufacturers' barrels.

It is very tight when screwing it in.
As others have said, if you use it with a plastic shaft, you will have a terrible time when it breaks.
I highly recommend it for carbon and metal shafts.

It's true that it doesn't loosen.
But it's really hard to remove it with a remover when it's broken. It might be OK for carbon shafts, but for plastic shafts, I would use O-rings.
Also, I don't think the cost performance is that good.

I bought it out of curiosity, as it was a hot topic among my darts friends.

I don't feel it loosening at all when I throw it (lol).
It is very tight when I install it.

Since it is meant to be disposable, it may not be suitable for those who change settings frequently.
On the other hand, if you are the type of person who always uses the same setting, this is the one for you! On the other hand, it will be useful for those who always use this setting, or those who use carbon shafts that are hard to break.

The elimination of shaft looseness is sure to have a significant impact on stress reduction during games, so if you are interested in this product, you should definitely try it!

Do shafts loosen that much?

With Fit, sometimes it's loose, but not enough to be concerned about...

If I put this on and screw it in and the shaft breaks, will I be able to remove it with a remover?

Hmmm...

It would be better if it worked on metal shafts!

I don't know if it can be used on metal shafts, but I kinda want it.

This is a very promising product.

The fact that it does not stick out, unlike conventional rings that do not loosen, is very attractive.

I am looking forward to the release of this product.