【TARGET】DAYTONA FIRE GT10 SOFT 20g 101941 's Japan Review

First of all, this barrel is not a perfectly straight barrel.
As you can see in the picture, the maximum diameter is at the front and the minimum diameter is at the rear because the barrel is slanted about 1.25% to the center of the barrel.

If you are a sensitive person, you will probably feel the taper more than the number.
It took me a while to get used to it, and my friend, who is a believer of straight, rejected it when I let him touch it.
If you really want to buy a straight one, don't buy it, because it's too expensive.

If you are interested in a fine barrel and have money, you may buy it.
The cut is comfortable and the tang is 95% cut, so you don't have to worry about the cut wear, but if you handle it roughly, it will chip easily because of its hardness.
Also, the screw holes are sharp, so if you just randomly put a shaft or tip in and tighten it, the threads will die even if it's carbon.
This happened to me when I lent it to a clumsy person.

As other reviewers have said, it tapers gently, but I didn't mind it.
The front part is hexagonal, but not exactly hexagonal like the RVB 95 Raymond Van Barneveld model. It feels more like a circle.
The rear section with the Target logo was actually part of the TI Carbon Pro Shaft Short 138100, not the barrel.
When you use other shafts, you have to remove it from this part.
The cut is not deep, but it is rather firm. But not too tight?
Personally, I think it is just right.

There are 9 carbon shafts in total, 6 of them are called for, but I don't need them because I don't use them.
To be honest, I don't need them because I don't use them anyway, so I wish they would lower the price a little more to compensate for that.