【Fit】["Carbon"] fis6401 ["Normal"] ["Spin"] 1 (13.0mm) 's Japan Review
3.67
6 Reviews
|
|
2 |
|
|
0 |
|
|
4 |
|
|
0 |
|
|
0 |
2013-01-08
It will not break unless you are very careful.
There is almost no sensation of loosening of the flight.
There are many lengths to choose from, so you can find the one that fits you best.
1 people found this helpful
2018-12-09
Two of them broke very quickly in two months.
They were burst and dropped, so they could not withstand the impact.
0 people found this helpful
2016-03-16
I took the plunge and bought one now that my settings were solidified.
I had heard that carbon is hard to break, but two of them broke from the flight side within a month.
I would like to think that I was unlucky.
2 people found this helpful
2013-01-12
With carbon, I don't think it will break unless something really bad happens.
You may think 13mm is "too short," but try throwing it for practice.
Surprisingly, you can use it to correct your habits.
1 people found this helpful
2014-01-19
It is more expensive than a regular shaft, but if you are a frequent breaker, carbon may be a better choice for you in terms of total cost.
0 people found this helpful
2016-02-04
I'm a little unsure if it's strong or weak...
When I was using my fitgear, I had a pattern of popping from the base, not the flight attachment area, and I didn't have that with the carbon. However, when I put the darts in a darts case with the shaft and the flight sticking out, I found that the flight attachment part was slightly bent, and when I kept throwing it, it broke.
I also wondered if it was a characteristic of carbon.
I kept removing and installing it, and the threads became stupid and it was useless.
After all, there were only two carbon shafts left...and I had to seal them up before I could experience their strength.
However, when I was throwing it, there was a slight difference in weight from the fitted gear, but I did not feel any discomfort.
I think this shaft is a good choice for those who keep their darts in a case that can protect the whole darts and have their own set-up in place.
Oh, by the way, I used the #8 shaft.
0 people found this helpful